FAQ
GENERAL
For all sales enquiries contact us at sales@vulcon.co.uk or call 01892 251992.
Please see our individual products pages for more information.
We strive as a company to be as sustainable as possible and use recycled products where we can. Our Bloc Seal for example is made from plastic that is 30% recycled. We are consistently reviewing the latest sustainable materials and technology available to the market so that we can integrate these into our product line.
We are proud to say that our products are manufactured in the UK to the highest standards. Our manufacturers hold certifications for both ISO9001 (Quality Management) and ISO14001 (Environmental Management), guaranteeing its quality and adherence to environmental best practices.
Yes, all of our products comply with the relevant approved building regulation documents. For more information, please contact our technical team.
As our products are new and innovative, they do not fall under the “harmonised European product standard” so do not require any markings.
Our products are designed by a combination of in-house team and third-party professionals such as structural and application engineers in accordance with the relevant building regulations documents. All our products are practically tested and certified by a UKAS approved laboratory.
DOR CAV
The Dor Cav is designed to be used on cavity widths ranging from 150mm down to 75mm.
The Dor Cav should be the same length as the door opening width or the nearest size up. For example, on a door opening of 900mm wide you would require a 1000mm Dor Cav that can then be cut down to 900mm on site.
We sell lengths of 1000mm, 1800mm and 2400mm. Note that Dor Cav’s can be abutted together on wider opening such as doors over 2400mm. For example, on a door opening that is 3200mm wide this would require 1 x 1000mm and 1 x 2400mm.
Please see our technical installation guide
Please see our technical installation guide
No, the Dor Cav is designed to sit under the insulation and screed to support it. It has not been designed to sit above this at finished ground floor level.
For all sales enquiries contact us at sales@vulcon.co.uk or call 01892 251992.
BLOC SEAL
Our Bloc Seal is the same size as a standard concrete building block, 440x215x100mm.
We currently sell one type of block that comes with 2 x offset aperture holes. This allows for 4 x positions to best suit your needs as the block can be rotated 180 degrees and both types of seals can be used in either aperture.
All blocks come as standard with 1x110mm seal for a normal soil pipe and a 1xcustom seal that can be used for any size pipe/duct ranging from 10mm to 110mm. Alternatively the 1xcustom seal can be left uncut as a blanking plug if not required.
Yes, we sell the custom seals separately if you want to swap this for the 110mm soil pipe seal giving you 2xcustom seals to use on a single block.
Please see our technical installation guide.
For all sales enquiries contact us at sales@vulcon.co.uk or call 01892 251992.
INSU CLIP
The Insu Clip is designed to hold 25mm PIR insulation securely in place where the external walls meet the screed to stop lateral cold bridging. 25mm PIR insulation is the thickness required to achieve the correct thermal levels as set out in building regulations document L.
No, the thin rolls of foam insulation that are sometimes provided with kits such as underfloor heating is to help with the expansion of screed against walls.
It should not be confused with correct 25mm PIR insulation that should be used on all external walls to meet document L and SAPS requirements.
We currently sell Insu Clips in bags of 20, 50 and 100.
Please see our technical installation guide.
For all sales enquiries contact us at sales@vulcon.co.uk or call 01892 251992.
